Hq Distortion - KETRON SD1000 Owner's Manual

2.0 HQ Distortion

HQ Distortion Top Level Controls
3Dh 00h Distortion ON/OFF: =0 OFF, else ON
3Dh 01h Noise Reduction: 0..4
3Dh 02h Booster: 0..3
3Dh 03h Type (Preset): 0..7 = OFF, Warm-Drive, Overdrive, Cry, Distortion, Metal, Max-
Saturation, Fuzz (using Preset parameter below)
3Dh 04h Drive: 0..127
3Dh 05h Tone: 0..127 (using PEQ parameters below)
3Dh 06h Level (Post-Gain): 0..127
HQ Distortion Preset Parameter Controls (see note below)
3Dh 10h Input High Pass Cutoff): 0..127
3Dh 11h Input High Pass Mode: 0..2
3Dh 12h Bias Level): 0..127
3Dh 13h Input Low Pass Cutoff): 0..127
3Dh 14h Input Low Pass Mode: 0..7
3Dh 15h Type (internal): 0-22
3Dh 16h Pre-Gain: 0..127 (should be set normally to 127, Distortion drive amount should be set by
"Drive" parameter, NRPN 3D04h)
3Dh 17h PEQ Freq low): 0..127
3Dh 18h PEQ Gain low): 0..64..127 = -12..0..+12dB
3Dh 1Ah PEQ Freq high): 0..127
3Dh 1Bh PEQ Gain high): 0..64..127 = -12..0..+12dB
HQ Distortion Routing Controls
3Dh 7Fh Routing switch of Distortion block: 0 = default, else input on MIC2IN (DAAD4R)
Note: details about the HQ Distortion Preset Parameters Controls please see dedicated Distortion Library module
documentation.
0
5