Power Trim And Tilt Switch On Bottom Cowling; Variable Trolling Rpm Switches - Yamaha F50 Owner's Manual

Components
EMU26155
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
the side of the bottom cowling. Pushing the
switch " " (up) trims the outboard motor up,
and then tilts it up. Pushing the switch "
(down) tilts the outboard motor down and
trims it down. When the switch is released,
the outboard motor will stop in its current po-
sition.
For instructions on using the power trim and
tilt switch, see page 72.
EWM01031
WARNING
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
falling overboard and could distract the
34
operator, increasing the risk of collision
with another boat or an obstacle.
UP
DN
1. Power trim and tilt switch
EMU30901

Variable trolling RPM switches

The trolling speed can be adjusted when the
outboard motor is trolling. Press the "
switch to increase the trolling speed and
press the " " switch to decrease the trolling
speed.
"
1. Variable trolling RPM switch
TIP:
The trolling speed changes approximately

50 r/min each time a switch is pressed.
If the trolling speed has been adjusted, the

engine returns to the normal trolling speed
when the engine is stopped and restarted
or when the engine speed exceeds ap-
1
ZMU07913
"