Warming Up Engine; Manual Start And Electric Start Models; Checks After Engine Warm Up; Shifting - Yamaha F50 Owner's Manual

Operation
EMU27670

Warming up engine

EMU27716
Manual start and electric start
models
1. After starting the engine, allow it to idle
for 3 minutes to warm up. Failure to do
so will shorten engine life.
2. Be sure the low oil pressure-alert indica-
tor goes off after starting the engine.
NOTICE: If the low oil pressure-alert
indicator blinks after the engine
starts, stop the engine. Otherwise,
serious engine damage could occur.
Check the oil level and add engine oil
if necessary. Consult your Yamaha
dealer if the cause for the low oil
pressure alert cannot be found.
[ECM01831]
EMU36531

Checks after engine warm up

EMU36541

Shifting

While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU36980

Stop switches

Turn the main switch to "

engine stop button and make sure the en-
66


EMU33492
EWM00180
ZMU07918
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01610
NOTICE
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the
engine, shift to neutral, then restart the
engine and allow it to warm up.
To shift out of neutral
1.
1. Neutral interlock trigger
2.
", or press the
gine stops.
Confirm that removing the clip from the en-
gine shut-off switch stops the engine.
Confirm that the engine cannot be started
with the clip removed from the engine
shut-off switch.
Shifting
WARNING
Pull the neutral interlock trigger up (if
equipped).
Move the remote control lever / gear
shift lever firmly and crisply forward (for
forward gear) or backward (for reverse