Assembly; Pre-Ride Inspection - Yerf-Dog Fun-Kart 3203A Owner's Manual

1. Complete the Fun-Kart registration and warranty confirmation on the back of this owner's manual and
mail in within 10 days of purchase. The information is required when ordering parts.
2. Steering Wheel - Bolt the steering wheel to the anchor plate with fasteners provided in the parts bag
included with the Fun-Kart. See "Steering Wheel Assembly Instructions" page 12.
3. Seat - Install the seat frame to chassis frame with fasteners provided in the parts bag. See "Seat
Assembly Instructions" page 13.
4. Brush Guard - Bolt the brush guard to chassis frame with fasteners provided in the parts bag. See
"Brush Guard Instructions" page 14.
5. Foam - Attach Foam to Brush Guard. See "Foam Attachment Diagram" page 15.
6. Bolts - Check the screws, nuts and bolts on your vehicle to see that all are tightened securely. For safe
operating conditions, do periodic checks and tighten securely.
Engine - Fill the crankcase with oil until it reaches the FULL mark
7.
on the dip stick.
For additional information refer to Tecumseh engine manual for servicing the engine.
Fill fuel tank with regular gasoline, leaded or unleaded. Do not use
8.
premium gasoline. Do not overfill (No fuel in filler neck).
9. Tire Pressure
It is common industry practice to over inflate the tires. This is done to guarantee an airtight seal. Prior to
riding the Fun-Kart for the first time, you may need to reduce the air pressure in the tires to the
specifications stated below:
Rear Tires
Front Tires
Proper tire pressures will increase the life of the tire and enhance the performance of the Fun-Kart.
Driving on asphalt or concrete will significantly reduce the life of the tire!!
DO NOT fill above the FULL mark
Approximately 20 oz. or 1¼ pints (.6 Liters) of SAE 30 weight oil.
CHECK AIR PRESSURE IN TIRES!!
10 PSI
12 PSI

PRE-RIDE INSPECTION

ASSEMBLY

6
.