SEAT ASSEMBLY INSTRUCTIONS
1. Locate the SEAT ASSEMBLY with LAP BELTS, and SHOULDER BELTS. Insert the bolt(9) and
washers(8)(99) into the bottem of the SEAT ASSEMBLY as shown.
2. Align the STUDS on the bottom of the SEAT ASSEMBLY with the SEAT TAB HOLES on the FUN-
KART FRAME.
3. Insert the STUDS into the SEAT TAB HOLES.
4. Secure the SEAT ASSEMBLY using four 5/16" FLAT WASHERS (101) and four 5/16"
NYLOCK NUTS (60).
5. Run pull cord through Eye Bolt(108) and attach Eye bolt to frame using Nylock Nut(55)
as shown below.
NOTE: The ends of the SHOULDER BELTS will be mounted onto the sides of the RACK
BRUSH GUARD in step 6 of the BRUSH GUARD ASSEMBLY INSTRUCTIONS on page 14.
14