Removing And Installing The Front Bezel; Installing Or Replacing A Memory Module - Lenovo ThinkCentre 7258 User Manual

Removing and installing the front bezel

This section provides instructions on how to remove and install the front bezel.
To remove and install the front bezel:
1. Remove the computer cover. See "Removing the computer cover" on page 14.
2. Release the three plastic tabs on the left side of the front bezel and pivot the
Figure 6. Removing the front bezel
3. To reinstall the bezel, align the plastic tabs on the right side of the bezel with
4. To complete the installation, go to "Completing the parts replacement" on page

Installing or replacing a memory module

Your computer has two slots for installing DDR2 DIMMs (double data rate 2 dual
inline memory modules) that provide up to a maximum of 4 GB of system
memory.
When installing memory modules, use the following guidelines:
v Use 1.8 V, 240-pin, DDR2 SDRAM (double data rate 2 synchronous dynamic
v Use 512 MB, 1 GB, or 2 GB memory modules in any combination up to a
To install or replace a memory module:
1. Remove the computer cover. See "Removing the computer cover" on page 14.
16
User Guide
bezel outward. Carefully set the bezel to the side without disconnecting the
power switch and LED assembly cable.
the corresponding holes in the chassis, then pivot the bezel inward until it
snaps into position on the left side.
43.
random access memory).
maximum of 4 GB.
Note: For this procedure, it helps to lay the computer on its side.