Removing And Installing The Front Bezel; Installing Or Replacing A Memory Module - Lenovo ThinkCentre M58e 7268 User Manual

Removing and installing the front bezel

This section provides instructions on how to remove and install the front bezel.
To remove and install the front bezel:
1. Remove the computer cover. See "Removing the computer cover" on page 14.
2. Release the three plastic tabs on the left side of the front bezel and pivot the
Figure 6. Removing the front bezel
3. To reinstall the bezel, align the plastic tabs on the right side of the bezel with
4. To complete the installation, go to "Completing the parts replacement" on page

Installing or replacing a memory module

This section provides instructions on how to install or replace a memory module.
Your computer has two slots for installing DDR2 DIMMs (double data rate 2 dual
inline memory modules) that provide up to a maximum of 4 GB of system
memory.
16
User Guide
bezel outward. Carefully set the bezel to the side without disconnecting the
power switch and LED assembly cable.
the corresponding holes in the chassis, then pivot the bezel inward until it
snaps into position on the left side.
44.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that was
included with your computer. To obtain a copy of the ThinkCentre Safety and Warranty
Guide, go to:
http://www.lenovo.com/support