Lenovo ThinkCentre 7258 User Manual page 35

10. Align the drive cage pivot pin with the slot 1 in the upper drive cage and
slide the hard disk drive cage into the chassis.
11. Connect the signal cable and the power cable to the rear of the new hard disk
drive.
Figure 19. Installing the primary hard disk drive and bracket
12. Press down on the metal latch 2 , pivot the drive cage into place, and then
slide it forward until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard
disk drive cage. The arrows are aligned when the hard disk drive is in
the proper position.
13. Go to "Completing the parts replacement" on page 43.
Chapter 2. Installing options and replacing hardware
27