Installation On Wall; Cabling Requirements; Fig. 3-3 Bottom View Of The Switch (Showing Mounting Holes) - Ovislink Live-FSH16T User Manual

Installation site preparation

Cabling requirements

Connecting to power

Installation on Wall

Live-FSH16T Fast Ethernet Switch can be mounted on a wall with wall anchors and
screws.
To mount the Switch on wall, please follow the steps below:
Drill two holes, the distance between both of which should be 9 cm (such as the
illustration below).
Insert wall anchors into these two holes.
Drive the screws into the top of the wall anchors.
Mount Live-FSH16T on the screws.

Fig. 3-3 Bottom View of the Switch (showing mounting holes)

Cabling Requirements
Live-FSH16T Fast Ethernet Switch is primarily targeted as a switching device to
concentrate your network traffic in a workgroup environment. It fits well into the
10BASE-T and 100BASE-TX cabling architecture to facilitate UTP end-station
connections to 10BASE-T/100BASE-TX network. The Uplink port also provides a
switch-to-switch cabling extension up to 100 meters.
The 16 RJ-45 station ports (MDI-X), which require either UTP or STP cable connection, is
compliant with 10/100 BASE Fast Ethernet standard. Thus, when configuring within the
10BASE-T/100BASETX cabling architecture, the UTP cabling distance should be within
a maximum distance of 100m.
9 cm
17