Led Indicators; Power Led; Station-Port Leds; Link/Rx Led - Ovislink Live-FSH16T User Manual

LED Indicators

The front-panel LED indicators enable users of Live-FSH16T Fast Ethernet Switch to
monitor the Power On/Off status of the Switch and the port status of each of its sixteen
10/100 Mbps station ports.
For the layout of LED indicators, please refer to Fig. 5-1 below.
As seen on Fig. 5-1, Power LED indicates the power on/off status of the switch. For each
station port, there are Link/Rx (Link/Activity), FDX/Col (Full-duplex/ Collision) and
100M LED to indicate its corresponding port status. You'll find the LED indicators to be a
very convenient way for hub or port status monitoring and troubleshooting.
Before connecting any network device to Live-FSH16T Fast Ethernet Switch, you should
take a few minutes to look over this section and get familiar with the front panel LED
indicators of your Switch.

Power LED

Power LED will give a solid green light when you turn on the Switch, and will be off when
the Switch being turned off. You can simply check the Power LED status to see if the
Switch is being activated or not. Before turning on the Switch, please verify that the power
cord has been properly connected the Switch to the power outlet on the wall.

Station-port LEDs

Link/Rx LED

Link/Rx LED giving a solid green light indicates that a data link has been established
between the corresponding port and the device. If the connection is faulty, it will be off.

Fig. 5-1 LED indicators

28