Table of Contents
Advertisement
Power-On the switch
The POE-FSH8PW Switch has a built-in power supply to operate with 100 ~ 240V AC,
50 ~ 60Hz power source.
The AC power cord connector is located at the rear of the unit and the On/Off switch is
next to the connector.
After the Switch is powered on, it will perform "self-diagnostic" test. This process takes
about 5 seconds to complete.
LED Table
LED
Power
LINK/AC
T
PoE
1.4 Installation Steps
This section lists the installation procedures in steps. Each step's instruction is thoroughly
explained in the subsequent sections of following chapter.
Step 1: Connect your device's passive PoE port to the switch's LAN port (See Figure A)
Step 2: Connect your PC to the switch.
AirLive POE-FSH8PW User's Manual
Status
Description
On
Power is on.
Off
Power is off.
On
Port is for connection.
Off
No connection.
Flashing
Data is transmitting or receiving
On
The POE function is enabled.
Off
The POE function is disabled.
4
1. Introduction
Advertisement
Table of Contents
