Advertisement
Necessary Tools and Equipment
The following tools may be necessary to install the SKC -500DC Gate opener. You will need
standard and Philips screw drivers, an electric drill, wire cutters and a wire stripper, a socket
set, and possibly access to a welder.
Site Preparation
Before you begin the opener installation, the gate should be mounted and moving freely,
there should be little resistance in the movement of the gate. The gate and pos t must be
suitable for being automated. Check that the structure is sufficiently strong and rigid, and that
its dimensions and weights conform to those listed in the specifications table of this document.
Make sure that the gate is plumb and level. The fence posts must be mounted in concrete.
The SKC -500DC is powered by 110V/60Hz AC power ; therefore, if you have not already done
so, wire a waterproof outlet near the gate following proper safety standards for your area. If
you are not experienced with this type of wiring or if your area requires it, hire a professional
electrician to perform this as well as wire in the SKC-500DC in the electrical section. The
SKC-500DC requires at least a 10A service. Make sure your electrician takes into account the
voltage drop involved in running many feet of wire to your installation location. If an
insufficient gauge of wire is used, there will be insufficient power at the site to operate the
opener. If you plan to use solar panels to power your gate, verify that you have sufficient
solar power to charge the battery and provide power for the number of openings and closings
you plan to need. Different areas of the planet receive varying amounts of sunlight, and that
amount varies on the time of the year. Make sure you account for all this in any solar
installation. If insufficient power is available, the opener battery can be permanently damaged
and this is not covered under the warranty.
Parts List
(1) Sliding gate operator
(1) Operator Base
(1) Magnetic limit switch
(2) Remote control
(2) Master Links
(2) 10 ft. Chain
(2) Chain Bolts
(2) Chain Brackets
(4) "U" Bolts for 2_ (51mm) for square & round gate frame
(4) 2 ¾_ (70mm) #48 Bolts for mounting operator to the base and washers
(4) 2 ½_ (64mm) Bolts for mounting Magnet brackets and washers
(4) 3 ¾_Anchor bolts, Anchors, Washers and Nuts (In the same bag with Manual release key)
(4) 5/8_ (15mm) Socket Head Cap screws for mounting chain box
(2) Manual release key
(2) Magnet brackets
(2) Magnets
2
(1) 1m BVR 0.7mm
antenna
(1) Owner's manual
Advertisement
