Advertisement
Chain
Close the gate and attach a chain bolt to the piece of chain that comes with the chain box
using enclosure master links. Tighten the chain bolt to the bracket with washers and nuts.
Pull the chain through the chain wheel box to the other chain bracket at the opposite end of
the gate. Connect the other end of the chain and the chain bolt, and then tighten the chain
bolt to the chain bracket. Thread up the chain by adjusting the chain bolt. Cut the chain to
length if necessary. Make sure that the chain is perfectly aligned with the chain holes on the
chain box. Tighten the chain by tightening the chain bolts at either end. See illustration
below.
Chain bolt
Master link
Chain
Electrical
Power
The control box should be equipped with a single -phase breaker (10A). Make sure that the
power is OFF before making any electrical connections. Remove the cover of the control box,
perform the wiring and replace the cover again. (See Fig.3 and wiring notes for control board)
Connect the supplied transformer to the control board at the AC IN terminal on JX-1 and plug
the transformer into an outlet. Verify that all electrical connections are water proof by
electrical outlets into exterior grade boxes with waterproof covers. Make sure that whenever
an electrical connecter enters or exits a box, it is se aled. If using solar, verify that all
connections are water proof and install solar power terminals into + and – terminals in JX-1.
Advertisement
