Engine - Husqvarna 968999250 Operator's Manual

ENGINE

LUBRICATION
Refer to you Engine Owners Manual
TO CHANGE ENGINE OIL (See Fig. 10).
• Be sure the mower is on a level surface.
• Oil will drain more freely when warm.
• Place a suitable container under the right
rear corner of the rear of the mower.
• Remove oil dipstick. Be careful not to
allow dirt to enter the engine when
changing oil.
• Using the clear plastic tube included with
you mower, place it over the end of the
drain valve located on the right side of
your engine.
• Place the other end of the tube thru the
2" diameter hole on the right side of the
rear deck.
• Be sure container is located under this
area of the mower.
• Using a 10 mm wrench, turn the hex
head on the oil valve counter clockwise
until the oil is draining out of the tube.
After the oil has drained, turn the hex
head clockwise until it is tight (do not
over tighten).
• Remove the plastic tube from the valve,
clean excess oil off of tube and store in a
safe place for the next use.
• Refill engine with oil through the oil
dipstick tube. Pour slowly. Do not
overfill.
• See Engine Owners Manual for type and
capacity of the oil.
CUSTOMER RESPONSIBILITIES
1
FIGURE 10
1. ENGINE OIL DRAIN
2. PLASTIC TUBE
34
2
CZ-13