Husqvarna 968999250 Operator's Manual page 21

TO ADJUST ANTI-SCALP
ROLLERS (See Figure 6)
Anti-scalp rollers are properly adjusted when
they are just slightly off of the ground when the
deck is at the desired cutting height in the
operating position. Anti-scalp rollers then keep
the deck in the proper position to help prevent
scalping in most terrain conditions.
NOTE:
Adjust Anti-scalp rollers with the mower
on a flat level surface.
• Adjust the deck to the desired cutting
height (see "TO ADJUST DECK
CUTTING HEIGHT" in the operation
section of this manual).
• Using a 3/4" wrench and a 9/16" wrench,
remove the nut and shoulder bolt from
the anti-scalp roller.
• Lower the anti-scalp roller to the ground,
and raise it up to the next highest hole.
• Replace and tighten the nut and shoulder
bolt.
• Be sure to adjust all of the anti-scalp
rollers to the same position.
• Be sure to readjust the anti-scalp rollers
if the cutting height is changed.
IMPORTANT:
THE ANTI-SCALP ROLLERS
MUST NOT BE USED FOR GAUGE WHEELS
OR THE ROLLER AND DECK MAY BE
DAMAGED.
OPERATION
21
FIGURE 6
1. ANTI-SCALP ROLLER
1
CZ-9