GE Monogram Use And Care Manual page 23

Questions?
PROBLEM
Use this
Ice clumps form
in the storage bin
problem
solver!
Water dispenser
does not work
Moisture forms on
cabinet surface
between the doors
Moisture
collects inside
Water on the floor
Rrefrigerator has odor
Interior light does
not work
Uneven spacing or
gaps between doors
and kitchen cabinet
Poor door alignment
or one door higher
than the other
If you need more help...call toll free:
GE Answer Center ® , 800.626.2000
consumer information service
The Problem Solver
POSSIBLE CAUSE
•
If you don't use the ice very often, ice clumps may form
in the storage bin and can clog the dispenser. Remove the
storage bin from the freezer and break up ice clumps with
your hands. Throw away any clumps that you can't break up.
•
Water supply line turned off or not connected.
•
Supply line may be clogged with sediment.
•
If no water is dispensed when the icemaker is first installed,
there may be air in the water system. Press the dispenser pad
for at least two minutes to remove trapped air from the
water line and to fill the water system.
•
Not unusual during periods of high humidity. If problem
persists, call for service.
•
Too frequent or too long door openings.
•
In humid weather, air carries moisture into refrigerator
when doors are opened.
•
If you use a glass over 6 inches tall, you may be jamming the
cubes in the funnel chute. They can fuse inside the chute
and drop out later, leaving water or ice on the floor.
•
Foods with strong odors should be tightly covered.
•
Check for spoiled food.
•
Interior needs cleaning.
•
Keep open box of baking soda in refrigerator; replace every
3 months.
•
No power at outlet. Call installer or electrician.
•
Light bulb needs replacing.
•
Check fuse and circuit breaker.
•
Kitchen cabinets are not level or square. Call the
installer or cabinetmaker.
•
Refrigerator not level. Adjust leveling legs so refrigerator
is resting solidly on the floor and is level side to side
and front to back.
Built - In Refrigerators
23