Husqvarna 9527SBEB Owner's Manual page 9

GASOLINE
FILLER CAP
MUFFLER
CHOKE
CON-
TROL
PRIMER
SAFETY
IGNITION
KEY
FUEL
SHUT-OFF
VALVE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for start ing en gine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Throttle/engine control - used to se lect either FAST or
SLOW engine speed and to STOP the engine.
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
OPERATION
DISCHARGE
CHUTE
THROTTLE
/ ENGINE
CONTROL
CLEAN-OUT TOOL
AUGER
ELECTRIC
CONTROL
START
LEVER
BUTTON
RECOIL
(AUXILIARY)
STARTER
HANDLE
CHUTE
DEFLECTOR
FIG. 10
Choke control - used for starting a cold engine.
Traction drive control lever - used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
LH and RH turn triggers - used to steer the snow thrower.
Defl ector remote control lever - used to change the
distance the snow is thrown.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the di-
rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
9
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED
CONTROL LEVER
DEFLECTOR REMOTE
CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
LH TURN
TRIGGER
LIGHT
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE