Subaru 2014 Legacy Owner's Manual page 51

Pre-Collision Braking System
Turning off the Pre-Collision Braking System
Pressing and holding the Pre-Collision Braking System OFF switch for approximately 2 sec-
onds (or longer) turns off the Pre-Collision Braking System (including Pre-Collision Brake
Assist). When this control is turned off, the Pre-Collision Braking System OFF indicator light
on the instrument panel illuminates. To turn the control back on, press and hold the Pre-
Collision Braking System OFF switch for approximately 2 seconds or longer again. When
this control is turned on, the Pre-Collision Braking System OFF indicator light turns off.
OFF
When the Pre-Collision Braking System is turned off, the Pre-Collision
Throttle Management Control function is also turned off.
Even when the Pre-Collision Braking System is turned off, if the ignition
switch is turned off and the engine is then restarted, the Pre-Collision
Braking System will be turned on. The system default setting when the
vehicle is restarted in “"ON”".
I Pre-Collision Braking System OFF indicator light
This indicator light illuminates when the
ignition switch is turned to the ON position,
and then flashes for approximately 7 seconds
after the engine starts. It turns off when the
Pre-Collision Braking System is turned off.
It also illuminates
conditions.
When the VDC OFF switch is pressed and
VDC is canceled
When the
malfunction
* Refer to page 71.
When the EyeSight system has stopped
temporarily
* Refer to page 72.
48
S00377
NOTE
under the
EyeSight system
following
has a
OFF
S00580
S00531