Roof Assembly - Arrow CO108-A Owner's Manual

Step 14
D27
1
Install a left roof panel at the left
rear and right front corner of the roof.
Install a right roof panel at the left
front corner of the roof.
2
Cut 28 short 3" (8 cm) strips off the
roll of weather stripping tape, and
put them aside. Cover the joint at the
peak with weather stripping tape.
Unroll the tape and press it down
over the opening at the ridge as you
install each roof panel. Do not cut the
tape at this time.
3
Install 2 narrow and 2 wide roof
panels in the sequence and posi-
tions shown on previous page. Fold
the lower section of the roof panels
down. Cover the notches with strips
of weather stripping tape. Save the
rest. Do not fasten the lower end of
the panels to the side wall angles at
this time. Continue weather stripping
the ridge opening.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
● Parts Needed For ●

Roof Assembly

8463 Left Roof Panel
5209 Roof Panel
6538 Roof Panel
8462 Right Roof Panel
Fasten At
Overlap with
Bolt
Screws To
Roof Beam
● ● ● ● ● 8462 Right Roof Panel (1)
● ● ● ● ● 8463 Left Roof Panel (2)
● ● ● ● ● 5209 Roof Panel (2)
● ● ● ● ● 6538 Roof Panel (2)
STEP
1
Weather Stripping
Tape Roll
Screws To
Roof Beam
Fasten At
Overlap with
Bolt
Do not fasten
at this time
STEP
2
5209
Strips
6538
STEP
3
27