Jeep Grand Cherokee 2012 Owner's Manual page 90

gap panel. They are not visible until you fold the gap
panel down. Do not use the cargo tie down hooks
located on the floor behind the seat. Finally, tighten all
three straps as you push the child restraint rearward and
downward into the seat, removing slack in the straps
according to the child restraint manufacturer's instruc-
tions.
WARNING!
Improper installation of a child restraint to the
LATCH anchorages can lead to failure of an infant or
child restraint. The child could be badly injured or
killed. Follow the manufacturer's directions exactly
when installing an infant or child restraint.
Installing Child Restraints Using The Vehicle Seat
Belts
The seat belts in the passenger seating positions are
equipped with an Automatic Locking Retractor (ALR) to
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 87
secure a Child Restraint System (CRS). These types of
seat belts are designed to keep the lap portion of the seat
belt tight around the child restraint so that it is not
necessary to use a locking clip. The ALR will make a
ratcheting noise if you extract the entire belt from the
retractor and then allow the belt to retract into the
retractor. For additional information on ALR, refer to
"Automatic Locking Mode" description under "Seat
Belts in Passenger Seating Positions" section. The chart
below defines the seating positions with an Automatic
Locking Retractor (ALR).
Driver
First Row N/A
Second Row ALR
Third Row N/A
• N/A — Not Applicable
• ALR — Automatic Locking Retractor
Center Passenger
N/A ALR
ALR ALR
N/A N/A
2