Set the day
Select the mode
This thermostat can be used to control an electric heating system
such as an electric baseboard heater, a radiant ceiling, a radiant
floor, an electric convector, etc.
The thermostat cannot be used with the following:
a resistive load under 2 A
a resistive load over 14.6 A
systems driven by a contactor or relay (inductive load)
central heating systems
One (1) thermostat
Two (2) 6-32 mounting screws
Two (2) solderless connectors
TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN
POWER PANEL TO AVOID ELECTRICAL SHOCK.
All cables and connections must conform to the local electrical
Special CO/ALR solderless connectors must be used when con-
necting with aluminum conductors.
Install the thermostat onto an electrical box.
Install the thermostat about 5 feet high, on an inside wall facing
Avoid locations where there are air drafts (such as the top of a
staircase or an air outlet), dead air spots (such as behind a
door), or direct sunlight.
Do not install the thermostat on a wall that conceals chimney or
The thermostat wires are not polarized; either wire can be con-
nected to the load or to the power supply.
Set the time
Program the schedule
Indicates that the
thermostat is configured
to conventional control
Period no. in
1) Connect the thermostat
Connect the thermostat wires to the power and to the load using
solderless connectors for copper wires.
Time and day
Appears when the
setpoint is displayed
Flashes when the
clock has been reset
a power failure
Setting no. in