Brickcom NR-04A User Manual page 53

3.3.3 Event Triggers
This section can be used to finish event configuration by setting:
Which channels will have event trigger function enabled
•
What is considered to be an event, and
•
Where the warnings will be sent to and how they will be sent.
•
Select Channels to Enable Event Trigger and Which Type of Event Should be
Triggered
Check the boxes to enable the event trigger for desired channels
•
Define which system events should trigger the recorder to send out
•
notifications
Define how and where notifications are sent
•
Note: Event trigger may not work for cameras that are placed outside of the local
network or on the Internet until the "UPnP Port Forwarding" is enabled on both the
NVR and the router.