Quickie All Court Owner's Manual page 15

A L L C O U R T
FOLDING BACK– ZERO OFFSET (FIG. A)
1. Remove screw (2), nut (3), eccentric washer (4) and offset
plastic saddle (5) from backplate / back rest assembly.
2. Aluminum– Swap the 1-3/4" long screw (2) for a 1-7/8" long
screw (2A) and the "offset" plastic saddle (5) (with the step in
it) for a plastic saddle (5A) without offset (no step).
Titanium– Swap the 1-7/8" long screw (2) for a 2" long
screw (2A) and the "offset" plastic saddle (5) (with the step in
it) for a plastic saddle (5A) without offset (no step).
3. Holding plastic saddle (5A) against backrest tube, slide the
sideguard (6) and plastic washer (7) between the backplate
(1) and the plastic saddle(5A), as shown in Fig. A.
4. Choose the side guard height by aligning one of the holes in
the side guard, with the holes in the backplate (1), plastic
washer (7), plastic saddle (5A) and backrest tube.
5. Insert screw (2A) through the eccentric washer (4), back-
plate (1), plastic washer (7), side guard (6), plastic saddle (5A)
and backrest tube. Attach nut (3).
6. Align slot in side guard with hole in seat frame.
7. Insert 1-7/8" long screw (8) through side guard bushing (9),
plastic washer (7), sideguard slot, 2nd plastic washer (7),
plastic saddle (5A), and seat frame. Attach nut (3A).
8. Secure screws (2A & 8) and nuts (3 & 3A).
9. Repeat procedure for opposite side.
10. Check backrest folding - if necessary, adjust tension in screw
(8) and nut (3A) to achieve proper folding function.
FOLDING BACK– 1/4" OFFSET (FIG. B)
1. Remove screw (2), nut (3) and eccentric washer (4) from
backplate / backrest assembly.
2. Aluminum– Swap the 1-3/4" long screw (2) for a 2" long
screw (2A).
Titanium– Swap the 1-7/8" long screw (2) for a 2" long
screw (2A).
3. Choose the side guard height by aligning one of the holes in
the side guard, with the holes in the backplate (1), plastic
washer (7), plastic saddle (5) and backrest tube.
4. Insert 2" long screw (2A) through the side guard (6), plastic
washer (7), eccentric washer (4), backplate (1), plastic saddle
(5) and backrest tube. Attach nut (3).
5. Align slot in side guard with hole in seat frame.
6. Insert a 2" long screw (2B) through side guard bushing (9),
plastic washer (7), sideguard slot, plastic washer (7), plastic
saddle offset (5) and seat frame. Attach nut (3A).
7. Secure screws (2A & 2B) and nuts (3 & 3A).
8. Repeat procedure for opposite side.
9. Check backrest folding - if necessary, adjust tension in screw
(2B) and nut (3A) to achieve proper folding function.
IX. SET-UP
Figure A – Folding Back, Zero Offset
Figure B – Folding Back, 1/4" Offset
15
ND DJUSTMENT
Backrest Tube
Seat Frame
Backrest Tube
Seat Frame
930491 Rev. C