D.backrest (Fixed Or Folding); Side Guard Installation - Quickie All Court Owner's Manual

A L L C O U R T
D. BACKREST (FIXED OR FOLDING)
1. Backrest Installation
To install backrest, remove the nut, plastic saddle and bolt from the backrest tube. Place the
backrest in the upright position and reinstall in the lower plate hole (A). Backrest bolts should be
tightened to 65 in-lbs. (7.3 Nm). Avoid over-tightening as you may crush the backrest tubing.
2. Back Angle Adjustment
Back angle adjustment is standard on all Quickie wheelchairs.
a. Loosen bolt and nut on both sides of
wheelchair.
b. Turn the eccentric washer (B) on the backrest hinge plate to increase or decrease the
back angle.
c. Tighten bolts and nuts.
d. The adjustment on each side of the chair must be exactly equal.
3. Height Adjustment (Aluminum only) (Excluding 9" back)
The backrest comes standard with a 3" height adjustment.
1. Remove the backrest upholstery from the frame.
2. You will see the backrest tube (C) which telescopes into the back frame and is secured
by a pushbutton (D) on the side of the backrest.
3. There are several holes, 1" apart in the back frame (E), from which you may choose to
set the back height.
4. Depress the pushbutton and move the backrest tube to the desired hole location.
5. Assure that the pushbutton fully engages into the back frame.
6. Slide the backrest upholstery back onto the back frame.
7. Secure the VELCRO® style material to the back frame.
E. SIDE GUARD INSTALLATION
(Following Pages)
Your All Court has been assembled with either a "Folding" or "Fixed" backrest. Determine
the configuration of your chair and follow the appropriate installation instructions.Two
mounting options are available for your side guards:
1. Zero Offset
The side guard width is the same as the seat frame width. The side guards mount inside the
backplate.
2. 1/4" Offset
Seat frame width will be 1/2" wider with side guards (1/4" per side).The side guards mount
outside the backplate.
930491 Rev. C
IX. SET-UP
14
ND DJUSTMENT
B
A
C
D
E