Programming A Favorite Channel; Programming A Master Power Macro; To Program The Master Power; To Operate Master Power Macro - One for All 6-Device Universal Remote User Manual

NOTE: Programming a new macro over
an existing one will erase the original
macro.
P
ROGRAMMING A
With so many channels available
through your cable or satellite system
provider, you can program a macro
that directly selects a favorite channel
with one key press.
For example, let's assume your
favorite cable programs are on
channel 52. Use the following
instructions to program a macro key
for direct access of this channel:
NOTE: This example assumes the TV is
tuned to the correct Input to view your
cable box.
Press and hold SET until the LED
1.
(red light) blinks twice, then
release SET.
Enter 9 9 5. The LED will blink
2.
twice.
3. Select an open macro key (e.g.,
M1) and press it once.
Press CBL/SAT once.
4.
5. Enter the channel number: 5 2.
NOTE: If you have access to over 100
channels, enter 0 5 2. Moreover, if the
original remote control requires you to
press ENTER to change the channel,
also press ENTER after the channel
number (e.g., 0 5 2 ENTER).
NOTE: You can program up to 20
functions on the macro keys.
6. Press and hold SET until the LED
blinks twice, then release SET.
Now when you press M1, you will
instantly see cable channel 52 on your
TV set.
P
ROGRAMMING A
M
ACRO
In its default state, the POWER key on
the One For All 6L Universal Remote
Control (URC-6020 B00) will
individually power your home
entertainment devices on or off.
However, you can also program a
Master Power Macro onto the POWER
key that will sequentially turn on or
off all the devices with a single key
press.
F C
AVORITE HANNEL
M P
ASTER OWER
To Program the Master Power Macro
1. Press and hold SET until the LED
(red light) blinks twice, then
release SET.
2. Enter 9 9 5. The LED will blink
twice.
Press the POWER key once.
3.
4. For the first device you want in
the power-on sequence, press its
device key (e.g., TV) once.
5. For the second device you want
in the power-on sequence, press
its device key (e.g., CBL/SAT)
once.
6. For the Third device you want in
the power-on sequence, press its
device key (e.g., AUD) once.
7. Repeat step 6 up to three more
times to add the other desired
devices to the power-on
sequence (e.g., VCR, DVD, and
PVR ).
8. To save the settings and exit the
program, press and hold SET
until the LED blinks twice, then
release SET.

To Operate Master Power Macro

1. After programming, point the
remote control at the devices
and press POWER for at least 2
seconds to sequentially turn on
(or off) your devices.
NOTE: When you press POWER for less
than 2 seconds, a power command will
only be sent to the currently-selected
device. This allows you to still
individually power devices on or off.
2. Devices will turn on (or off)
according to your programmed
sequence.
NOTE: The currently-selected device
will always turn on or off first, followed
by the remaining programmed
sequence. After the master power
sequence has been completed, the
remote control will be set to control the
first powered-on device.
NOTE: If one or more devices does not
have a POWER key, the power off/on
sequence may be slightly delayed when
the remote control signals the
device(s).This action is normal.
O ' M
WNER S ANUAL
Using Macros 9