Table of Contents
Advertisement
13 - 12 Symbol DS3408 Product Reference Guide
User-Programmable Supplementals
Supplemental 1: Parameter # F1h 43h
Supplemental 2: Parameter # F1h 44h
If you selected a Supplemental User-Programmable option from
13-9, select User-Programmable Supplemental 1 to set the 3-digit prefix. Then select the 3 digits using the
numeric bar codes beginning on
prefix. Then select the 3 digits using the numeric bar codes beginning on
User-Programmable Supplemental 1
UPC/EAN/JAN Supplemental Redundancy
Parameter # 50h
With Autodiscriminate UPC/EAN/JAN Supplementals selected, this option adjusts the number of times a
symbol without supplementals is decoded before transmission. The range is from two to thirty times. Five or above
is recommended when decoding a mix of UPC/EAN/JAN symbols with and without supplementals, and the
autodiscriminate option is selected. The default is set at 10.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes in
Numeric Bar
Codes. Single digit numbers must have a leading zero. To correct an error or change a selection,
scan Cancel on
page
UPC/EAN/JAN Supplemental Redundancy
page D-1.
Select User-Programmable Supplemental 2 to set a second 3-digit
D-3.
Decode UPC/EAN/JAN Supplementals on page
page D-1.
User-Programmable Supplemental 2
Appendix D,
Advertisement
Table of Contents
