NComputing L230 User Manual page 41

Double-clicking on an entry in the table brings up the "Device Properties" window that
shows a list of properties and buttons for changing the device's settings.
The settings you can change are all the same settings you can change when you use
the "Options" window on the access device itself. See the access device setup section
for details on these settings.
Note: There are four settings you can change in the "Device Properties" window that you
can't change in the access device's "Options" window.

One is the device's name. You can configure it on the management console by
clicking on the "Connection Settings" button.

The second is the access device's group membership. You can add the access
device to a group or multiple groups by clicking the "Member of Groups" button
and adding the groups to the list.

The third is enabling and disabling USB on the selected device. In the "Device
Properties" window, there is a checkbox labeled, "Enable USB on this device".
 The fourth is the "Auto-Connect" feature. It is available under the "Connection
Settings" button in device configuration. This feature enables configuring the
access device to automatically connect using a specific profile when it is
restarted or logged off.
You can print the access devices's information by clicking on the "Print" button.
For L230 devices, a check box appears on the Device Properties screen that allows the
administrator to specify whether or not the USB port can be used on that access device.
40
L230/L130 User Manual