Playback; Turning The Power; Setting The Top Priority Playback Layer For Super Audio Cds - Denon DCD-2020AE Owner's Manual

Playback

Turning the power on
Before using a remote control unit, insert the batteries
"Inserting the batteries").
CD X
Press to turn on power to the
unit.
• The power indicator lights green and the
power turns on.
• The "NO DISC" message is displayed if a disc is not loaded.
When power is switched to standby
CD X
Press .
The power is set to the standby mode.
GPower indicator statusH
• Normal standby : Red
• Auto standby : Off
• iPod charge standby : Orange
n Turning the power off
X
Press on the main unit.
• The power indicator turns off, and so does the power.
• Be sure to stop playback before turning the power off.
• Make sure that the disc tray is completely shut before turning off
the power.
NOTE
Power continues to be supplied to some of the circuitry even when the
power is in the standby mode. When leaving home for long periods
of time or when going on vacation, either press
turn off the power, or unplug the power cord from the power outlet.
CD

Setting the top priority playback layer for Super Audio CDs

(vpage 23 • The layer that is played with priority when the disc is loaded can be
set.
• Upon purchase, the priority layer is set to the "STEREO".
1
CD X
Press
the unit.
2
Check that no disc is loaded.
• If the layer is switched while the disc is being loaded, the playback
layer switches for that disc, but the top priority playback layer
setting itself does not change.
3
Press SOURCE
"DISC".
4
DISC LAYER
Press
to set (Super Audio CD only).
Plays back the 2-channel area of the Super Audio
STEREO
CD (the default setting).
MULTI Plays back the multi-channel area of the Super
Audio CD. The analog output of the DCD-2020AE
outputs a down-mixed 2-channel signal.
CD Plays back the CD layer of the Super Audio CD.
• When a disc is loaded after the setting has been made, the contents
recorded on the set layer are displayed.
• If a disc that does not contain the layer set for top priority playback
is loaded, the contents recorded on another layer are displayed
X
on the main unit to automatically.
• This setting is stored in the memory and is not cleared even when
the disc holder is opened or closed or the power is turned off. To
change the setting, repeat the procedure above.
to turn on power to
to set the playback media mode to
and switch to the layer you want
STEREO MULTI
CD
10
• The priority playback layer cannot be set when a disc is inserted or
"OPEN" is shown on the display.
• During playback of the multi-channel area, the analog output of the
DCD-2020AE plays back a 2-channel downmix.
• If the area and layer have not been set for a disc, the priority playback
order is as follows:
q STEREO w MULTI
• This setting is memorized by the DCD-2020AE and is retained even
if the disc tray is opened/closed or the power is switched on/off.
Please reconfigure the settings if you wish to change them.
e CD