TYAN S2692 User Manual page 53

3.4.7 I/O Device Configuration
This setting allows you to configure I/O devices.
Main
Serial port A:
Base I/O address:
Interrupt:
Parallel port:
Mode:
Base I/O address:
Interrupt:
DMA channel:
↑↓
F1 Help
← →
Esc Exit
Serial Port A:
This defines how the first serial port is detected and configured.
Options: Disabled / Enabled
Base I/O Address:
Set the base I/O address for serial port A.
Options: 3F8 / 2F8 / 3E8 / 2E8
Interrupt:
Set the interrupt for serial port A.
Options: IRQ3 / IRQ4
Parallel Port
This defines how the parallel port is detected and configured.
Options: Disabled / Enabled
Mode
This field allows the user to select the parallel port mode. The default value is
Standard that automatically selects the correct mode to use. The other modes are
explained as follows:
SPP works with all parallel port devices. However, it is the slowest transfer mode
and should only be used when faster transfer modes cannot be used.
There are two faster bidirectional modes available - the ECP (Extended Capabilities
Port) and EPP (Enhanced Parallel Port) modes.
PhoenixBIOS Setup Utility
Advanced
I/O Device Configuration
Select Item
Select Menu Enter
http://www.tyan.com
Security
[Enabled]
[3F8]
[IRQ 4]
[Enabled]
[SPP]
[378]
[IRQ 7]
[DMA 3]
-/+ Change Values
 Sub-Menu
Select
53
Boot Exit
Item Specific Help
Configure using these
options:
[Disabled]
No configuration
[Enabled]
User Configuration
[Auto]
BIOS or OS chooses
configuration
(OS Controlled)
Displayed when
controlled by OS
F9 Setup Defaults
F10 Previous Values