Maintenance; Maintenance Schedule; Service - Husqvarna 13 AWD Operator's Manual

The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.

Maintenance

Cleaning
Check the engine's oil level
Check the engine's cooling air inlet
Check the fuel pump's air filter
Check the steering wires
Check the brakes
Check the battery
Check the safety system
Check screws and nuts
Check for fuel and oil leakage
Clean around the silencer
Inspecting the silencer
Change the engine oil
Clean the air filter's pre-filter
Check the cutting unit
Check the tyre pressures (60 kPa / 8.5 PSI)
Lubricating the belt adjuster
Lubricate joints and shafts
Adjust the brakes Rider 11 and Rider 11 C
Check the V-belts
Check the transmission's cooling flanges
Rider 13 C, Rider 13 AWD and Rider 15 C
Check the transmission's oil level
Rider 13 C, Rider 13 AWD and Rider 15 C
Adjust the brakes Rider 13 C and Rider 15 C
Adjust the brakes Rider 13 AWD
Check and adjust the throttle wire
Clean the cooling flanges on the engine and
transmission 2,4)
Replace the air filter's pre-filter and paper filter
Replace the fuel filter
Replace the plug
Check the valve clearance
Check the need of an oil change
the gearbox/hydraulic system
1) First change after 5 hours. Replace after every 25 hours with heavy loads or high temperatures.
and replacement should be more frequent.
authorised service workshop.
= Described in these instructions.
= Not described in these instructions.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cable is removed from the plug.
MAINTENANCE

Maintenance schedule

1)
2)
3)
3)
4)
4,5) in
3)
For daily use of the machine lubrication should be conducted twice a week.
5) Rider 13 AWD only. Replace first after 8 hours.
Daily
mainte-
Page nance
before start
24
42
35
32
27
28
32
33
–
–
–
26
42
31
36
35
43
44
28
–
–
43
28
29
30
–
2) 31
30
32
–
–
• The parking brake is applied.
• The cutting unit is disengaged.
Maintenance interval
At least
once in hours
a year
25 50 100
1) 1)
2) During dusty conditions cleaning
4)
Conducted by
English –
200
23