Advertisement
spECIfICATIONs
Battery pack
Voltage
Charger input
Battery capacity
No. of cell for battery
Maximum charging time
(BCL3620)
Quick recharge (1 hour)
OpERATION
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
Never operate the charger where there is a possibility of
inflammable or explosive gasses or vapour. Keep well
away from petroleum, paint and cleaning supplies and
gas fired heating systems.
Charge in a well ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.
CHARGING THE BATTERY pACk
Battery packs are shipped in a low charge condition to
prevent possible problems.
them until the LED on the front of the charger glows green.
CHARGING A HOT BATTERY pACk
When using a tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack
cool down for approximately 30 minutes before attempting
to recharge.
NOTE: This situation only occurs when continuous use
BPL3626
36V
220V-240V,
50Hz-60Hz AC only
2.6Ah
20
100 minutes
60%
WARNING
WARNING
WARNING
WARNING
Therefore, you should charge
English
of a tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to CHARGING
A COOL BATTERY PACK for normal recharging of
batteries. If the charger does not charge the battery pack
under normal circumstances, return both the battery pack
and charger to your nearest Authorized Service Center
an electrical check.
CHARGING A COOL BATTERY pACk
„ Only charge the Ryobi battery pack BPL3626 with this
charger.
„ Make sure the power supply is normal household
voltage, 220-240 V, 50-60 Hz, AC only.
„ Make sure the battery pack latch snaps into place
and the battery pack is secured in the charger before
beginning operation.
„ Make sure the power cord is fully seated in the charger
socket.
„ Connect the charger to the power supply.
„ Slide the battery pack along the groove of the charger.
Be sure that contacts on the battery pack engage
properly with contacts in the
NOTE: After charging is complete, the charger LED
will remain on with green color until the battery pack is
removed from the charger or charger is disconnected from
the power supply.
„ The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
„ Do not place the charger and battery pack in an area
of extreme heat or cold. They will work best at normal
room temperature.
NOTE: The charger and battery pack should be placed in
a location where the temperature is more than 10°C but
less than 38°C.
„ When batteries become fully charged, unplug the
charger from the power supply and remove the battery
pack.
„ To remove the battery pack from the charger, depress
the battery pack latch.
4
for
charger.
Advertisement
