Advertisement
NOTE: When the battery becomes fully charged, the green
LED is on for 10 minutes. It is normal for the battery pack to
become slightly warm to touch while charging.
■
Do not place the charger and battery pack in an area of
extreme heat or cold. They work best at normal room
temperature.
NOTE: When charging, the charger and battery pack should
be placed in a location where the temperature is more than
10°C but less than 25°C.
CHARGING A COOL BATTERY PACK
See Fig. 2
1. Align the raised rib on the battery pack with the groove in
the product, and slide in the battery pack. Make sure that
the battery pack latch clicks into place.
2. Connect the product to a power supply.
See Fig.3
1. Disconnect the product from the power supply when the
battery pack becomes fully charged.
2. Press the battery pack latch to unlock the battery pack
from the product.
3. Slide the battery pack off the product.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the cells in the battery pack
become hot. A hot battery pack should be allowed to cool
down for approximately 30 minutes before recharging.
MAINTENANCE
■
When not using or when cleaning the product, disconnect
it from the power supply and remove the battery pack.
■
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents. Use clean cloth or soft brush to remove dirt
and dust.
■
Do not, at any time, let brake fluids, gasoline, petroleum-
based products, and penetrating oils come in contact
with plastic parts. These products contain chemicals that
can damage, weaken, or destroy plastic.
■
Hazardous voltages are present within the product; do
not disassemble.
■
If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the manufacturer
or its service agent.
CLEANING THE CHARGER
■
Unplug the charger power cord from power supply
before cleaning to prevent serious personal injury.
■
Clean the charger surface (except labels) using a damp
cloth with a mild detergent.
■
Do not use any strong detergents on the plastic housing.
They can be damaged by certain aromatic oils, such as
pine and lemon, and by solvents such as kerosene.
■
Moisture can cause a shock hazard. Wipe off any
moisture with a soft dry cloth.
STORAGE
Store the product in a cool, dry place between 10°C and
38°C.
SYMBOLS ON THE PRODUCT
Class II: Protection against access to
live parts
Regulatory Compliance Mark (RCM).
Product meets applicable regulatory
requirements.
Indoor use only
Time-lag type fuse
To reduce the risk of injury, user
must read and understand operator's
manual before using this product.
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.
Do not use the product in a vertical
position when used with a BPL3660D,
BPL3690D, or BPL3612D battery pack
unless it is mounted on a wall. Use the
product in a horizontal position only.
SYMBOLS IN THIS MANUAL
Parts or accessories sold separately
Note
Warning
SPECIFICATIONS
Charger
Weight
Weight with 3 heaviest
battery packs
Voltage
Charger input
Input current
Charger output current
R36CHR3P
1.8 kg
9.7 kg
36 V d.c.
220–240 V AC,
50/60Hz
2 A max
4 A max
3
Original Instructions
Advertisement
