Replacement Parts - Jet JWBS-20 Operating Instructions And Parts Manual

Troubleshooting
Trouble
Saw stops or will not
start.
Does not make
accurate 45° or 90°
cuts.
Blade wanders during
cut.
Saw makes
unsatisfactory cuts.
Blade does not come
up to speed.
Saw vibrates
excessively.

Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call
1-800-274-6848 between 7:30 a.m. and 6:00 p.m. (CST), Monday through Friday. Having the Model
Number and Serial Number of your machine available when you call will allow us to serve you quickly and
accurately.
Probable Cause
Overload tripped.
Saw unplugged.
Fuse blown or circuit breaker tripped.
Cord damaged.
Stop not adjusted correctly.
Angle pointer not set accurately.
Miter gauge out of adjustment.
Fence not aligned with blade.
Warped wood.
Excessive feed rate.
Incorrect blade for cut.
Dull blade.
Blade mounted incorrectly.
Gum or pitch on blade.
Incorrect blade for cut.
Gum or pitch on table.
Extension cord too light or too long.
Low shop voltage.
Base on uneven floor.
Bad v-belt.
Bent pulley.
Improper motor mounting.
Loose hardware.
Remedy
Allow motor to cool, then reset by
pressing the OFF switch.
Check plug connections.
Replace fuse or reset circuit breaker.
Replace cord.
Check blade with square and adjust
stop.
Check blade with square and adjust
pointer.
Adjust miter gauge.
Check and adjust fence.
Select another piece of wood.
Reduce feed rate.
Change blade to correct type.
Replace blade.
Teeth should point down.
Remove blade and clean.
Change blade to correct type.
Clean table.
Replace with adequate size cord.
Contact your local electric company.
Reposition on flat, level surface.
Replace v-belt.
Replace pulley.
Check and adjust motor.
Tighten hardware.
18