To De-Register A Handset; Factory Reset - Raymarine SmartController User Manual

81243_1.fm Page 38 Tuesday, December 7, 2004 10:06 AM
The SmartController will now search for
the basestation, you can press EXIT at
any time to stop the search. When a
basestation is found by the
SmartController, check that the yellow
registration light on the basestation is on.
If the yellow light is on, then press
ACCEPT to complete the registration, the
display will read REGISTER SUCCESSFUL.
Otherwise, press REJECT and re-start the
registration procedure

To de-register a handset

At REGISTRATION, press SELECT.
If the SmartController is already
registered, then the display will read
REGISTERED TO BASESTATION. Press
DEREG to continue, or EXIT to cancel the
operation.
The SmartController will attempt to
commuicate with the basestation and de-register. When complete, the
display will read HANDSET NOT REGISTERED.
If the SmartController cannot communicate with the basestation then a
"BASE NOT FOUND" message will be displayed. It is still possible to de-
register the SmartController at this point by pressing SELECT. To leave
without de-registering, press EXIT.

Factory Reset

This option will clear all settings from the SmartController. Press and hold
the SELECT key for 2 seconds to activate the reset.
Note: A reset does not alter the registration status of the SmartController
38
REGISTER
HANDSET
CHECK
BASESTATION
POWERED
EXIT START
FOUND
BASESTATION
CHECK
LAMP
REJECT ACCEPT
REGISTERED
TO
BASESTATION
EXIT DEREG
User Guide