Sailing Timer Mode; Infomation Shown In Sailing Timer Mode; Sailing Timer; Timer 1 - Chronometer - Oregon Scientific OUTBREAKER RA201 User Manual

SAILING TIMER MODE

INFORMATION SHOWN IN SAILING TIMER MODE
Four information can be shown in sailing timer: local pressure, clock,
altitude and temperature. Press SELECT to access the information
one by one.
Refer to Fig. 5 to toggle between the information in sailing timer
mode.
Local pressure Clock
SELECT
FUNC
FUNC
Timer 2-10 min sailing timer
Timer 3-6 min sailing timer
Fig. 5
Fig.5

SAILING TIMER

RA201 is equipped with three sailing timers: TIMER 1 –
chronometer with 99 laps memory; TIMER 2 – 10 minutes pre-set
timer; & TIMER 3 – 6 minutes pre-set timer.
SELECT
Temperature
Altitude
SELECT SELECT
FUNC
FUNC
Fig. 5a
Timer 1 -Chronometer
1. Press FUNC from any one of the display modes: sail-local
pressure, sail-clock, sail-altitude and sail-temperature to access
to the sailing timer.
2. Either TIMER 1 [
[ ] can then be toggled to select by pressing FUNC. Refer to
Fig. 5a to toggle between the three sailing timers.
Notes:
a) This chronometer works independently with the chronometer in
calendar clock mode.
b) This chronometer can run simultaneously with the chronometer
in calendar clock mode.
c) If the chronometer is used as a timer, after reset it will go back to
set time in the timer mode. The chronometer can be used as a
stopwatch only when the time shows 00:00:00
d) In the Sailing timer mode, only one of the timers, either TIMER
Fig.5a
1, TIMER 2 or TIMER 3, can be run at a time.
e) Whenever re-entering the SAILING TIMER mode while the
watch in Sailing Timer mode is running, it will automatically
revert to the last running timer.
TIMER 1 – Chronometer
Timer 1 can be used as a stopwatch with 99 laps memory function
as well as a countdown timer.
15
] or [ ], TIMER 2 [ ] and TIMER 3