System Information And Reset Tv; System Information; Automatic Power Down; Reset Tv - Toshiba RV6**D Digital Series Manual

System Information and

Reset TV

System Information

This feature can be used to check the version of software
currently installed. When in DTV mode, it includes additional
diagnostic information such as signal strength, signal quality,
centre frequency, modulation, etc.
a
From the SETUP menu press
Information.
b
Q
Press to display the System Information.
System Information
2.1.26.0 Feb 19 2009 - 15:56:50 FW:13
WEAK
Ch22
Ch25
Ch35
Ch46
c
For information about the signal quality of a particular
B
multiplex, press
d
Q
Press for a screen showing detailed technical
information about the selected multiplex.

Automatic Power Down

The TV will automatically turn itself off (standby) after
approximately 4 hours, if you do not touch the control buttons
on the remote control or on the TV control panel.
a
In the SETUP menu, press
Down is highlighted.
b
C c
Use or to select On.
Reset TV
Selecting Reset TV will reset all TV settings, including saved
channels, to their original factory values.
a
In the SETUP menu press
highlighted.
b
Q
Press to select. A screen will appear warning that
all settings will be lost. Press
When the set powers back on, the Quick Setup screen
will appear. Press
perform an auto tune. (See 'Quick Setup' section on
page 13.)
B b
or to select System
TOSHIBA
2009
AVERAGE STRONG
Good
Good
Good
b
or to select that multiplex.
b
until Automatic Power
b
until Reset TV is
Q
to continue.
Q
to advance the setup and

PC Settings

Horizontal and Vertical Position

Connect the PC (as shown in the 'Connecting a PC' section) and
ensure that a picture is showing on the television screen. The
picture position may now be adjusted to suit personal
a
Press
SETUP menu.
SETUP
Country
Ant/Cable In
Auto Tuning
ATV Manual Tuning
DTV Manual Tuning
DTV Settings
Poor
AV Connection
PC Settings
b
Press
c
or
PC Settings
Horizontal Position
Vertical Position

Clock Phase

Sampling Clock
The Clock Phase matches the PC signal with the LCD display.
Adjusting this can clear horizontal stripes and picture blur.
a
In the SETUP menu press
highlighted.
b
Press
c
Use
39
CONTROLS AND FEATURES
preference.
o
to select PC, then select PC Settings from the
Q
B b
. Press and to select an option, then
to adjust the settings.
0
0
0
0
Reset
Clock Phase
b
until PC Settings is
Q
b
to select, then to highlight Clock Phase.
C c
or to adjust until the picture clears.
UK
Antenna
C