Honda Insight 2000 Owner's Manual page 166

Main Menu
6. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator.
Apply non-hardening sealant to the
drain bolt threads, put a new
washer on the drain bolt, and
reinstall the bolt in the engine
block. Tighten it securely.
Tightening torque:
61 Ibf . ft (83 N . m , 8.5 kgf . m)
7. Mix the recommended antifreeze
with an equal amount of purified
or distilled water in a clean
container. The cooling system
capacity is:
0.61 US gal (2.3 , 0.51 Imp gal)
Table of Contents
CAP
BLEEDER BOLT
8. Remove the engine cover.
9. Loosen the bleeder bolt on top of
the engine. Pour coolant into the
radiator up to the base of the filler
neck. Tighten the bleeder bolt
when coolant comes out in a
steady stream with no bubbles.
Install the radiator cap.
10.Remove the cap from the water
outlet, and install a pipe and funnel.
Cooling System
11.Pour coolant into the funnel until
the coolant stops flowing into the
engine.
12.Start the engine and let it run for
about 30 seconds. Then turn off
the engine.
13.Pour coolant into the water outlet
up to its edge. Install the cap.
14.Install the engine cover.
Maintenance
CONTINUED