Wiring Your Cw-80 Transformer - Lionel A Christmas Story Owner's Manual

Creating your layout
Wiring your CW-80 Transformer (continued)
5. Plug the CW-80 Transformer into your wall outlet (120 volts).
As your layout expands, you may also make power connections with the stripped ends of wires,
placing no more than two wires on each terminal. For best performance on large layouts, it is
recommended that you use 16-gauge wire to connect your CW-80 Transformer to the track. On larger
layouts where several track connections are required, the use of separate junctions/terminal strips
(available at your local electronics store) is recommended to prevent voltage drops.
To prevent the excessive build up of heat, be sure to select the proper wire gauge for
Caution!
your layout. Follow these guidelines:
• Track connections must be made with 18-gauge wire or heavier. Larger layouts
require a minimum of 16-gauge wire.
• Use 24-gauge wire only when connecting single accessories that require lower
current.
• When wiring multiple accessories (two or more) or accessories that require higher
current, be sure to use 18- to 16-gauge wire.
fastrack terminal section
Figure 4. Controller connections
spade-shaped
connector
notch
TRACK ACCESSORY
A
U
0~18VAC
8
B
U
120/60z
0~18VAC