Section.5:.Installing.the.rudder; Section.6:.Propeller.balancing - ProBoat Miss Elam Owner's Manual

Section 4: Installing the Radio System Batteries (cont)
m.4..Plug.the.switch.harness.into.both.the.receiver.
and.the.battery.box.following.the.instructions.
provided.with.the.radio..Secure.the.radio.box.
cover.with.the.hex.head.screws.
Transmitter Batteries
m.1..Remove.the.transmitter.from.the.box.
m.2..Remove.the.battery.cover.on.the.bottom..
of.the.transmitter.
m.3..Insert.8.AA.alkaline.batteries.into.the.battery.
holder..Note.proper.polarity.
m.4..Insert.the.battery.holder.in.the.transmitter.
following.the.directions.provided.with.the..
radio.system.
m.5..Install.the.battery.cover.back.into.position.on.
the.bottom.of.the.transmitter.
m.6..Turn.on.the.transmitter.and.confirm.that.the.
LCD.illuminates,.indicating.proper.installation.of.
fully.charged.batteries.
m.7..Turn.on.the.receiver.switch.and.move.the.
controls..Confirm.that.all.controls.operate.in.
the.proper.direction.and.are.controlled.by.the.
proper.transmitter.input.
m.8..Turn.the.transmitter.and.the.receiver.switch.
off..To.keep.the.boat.from.receiving.stray.
signals,.the.transmitter.should.be.turned.on.first,.
followed.by.the.receiver..Likewise,.the.receiver.
should.be.turned.off.first,.then.the.transmitter.
Note:.Remember.the.transmitter.
must.be.sending.a.signal.the.entire.
time.the.receiver.is.on.

Section 5: Installing the Rudder
Parts Required
Rudder
2.5mm.hex.screw
Tools and Adhesives Required
2.5mm.hex.driver
m.1..Locate.the.stainless.steel.rudder.and..
2.5mm.hex.screw.
m.2..Carefully.insert.the.rudder.as.shown.
Section 6: Propeller Balancing
For.optimum.performance,.propeller.balancing.can.
add.several.mph.to.top.speed.and.reduce.vibration..
There.are.several.different.propeller.balancing.tools.
available..Read.the.instructions.that.accompany.
the.propeller.balancing.tool.regarding.removing.
material.from.the.propeller..Removing.material.from.
the.correct.part.of.the.propeller.is.crucial.to.the.
performance.of.the.propeller..Contact.a.local.hobby.
retail.store.for.assistance.
m.3..Find.the.flat.spot.on.the.rudder..Put.screw-.
locking.compound.on.the.2.5mm.hex.screw.
threads.and.tighten.the.screw.on.the.flat.spot..
as.shown.