Makita 4101RH Instruction Manual page 6

Bevel cutting
1
Loosen the wing nut on the bevel scale plate on the front
of the base. Set for the desired angle (0° - 45° ) by tilting
accordingly, then tighten the wing nut securely.
Loosen the wing bolt on the depth guide and move the
base so that the end of the blade case is above the red
line on the depth guide. Then tighten the wing bolt to
secure the base.
NOTE:
• If the end of the blade case is under the red line on
the depth guide, the outer flange may hit the work-
piece when you perform the bevel cut.
Sighting
2
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the B
position with it.
003515
1. Wing nut
003516
1. Wing bolt
1
2. End of blade
case
3. Red line
2
3
003520
1
1. Base
2. Top guide
A
B
Switch action
1
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing diamond wheel
1
Hold the outer flange with the wrench and loosen the hex
socket head bolt clockwise with the hex wrench. Then
remove the hex socket head bolt and outer flange.
Install the diamond wheel, outer flange and hex socket
head bolt onto the spindle. Hold the outer flange with the
wrench and tighten the hex socket head bolt counter-
clockwise with the hex wrench. BE SURE TO TIGHTEN
THE HEX SOCKET HEAD BOLT SECURELY.
6
003523
1. Switch trigger
2. Lock-off button
2
003528
1. Wrench 22
2. Hex wrench
2