Sony Bravia KDL-37S4000 Operating Instructions Manual page 32

Programme Sorting
Programme Block
Intelligent Picture
Manual Programme
Preset
32
GB
Changes the order of analogue channels stored in the TV.
1
Press F/f to select the channel you want to move to a new position, then press
.
2
Press F/f to select the new position for the channel, then press
Blocks an individual channel from being watched.
F f
1
Press / to select the channel you want to block, then press
2 F f
Press / to select "Block", then press
To watch the channel, select "Allow".
On with Indicator Automatically reduces the picture noise. The signal level bar
is displayed when the channel is changed or the display is
changed from an input screen to a TV programme.
On Automatically reduces the picture noise.
Off Turns off the "Intelligent Picture" feature.
Before selecting "Label"/"AFT"/"LNA"/"Audio Filter"/"Skip"/"Colour System",
press PROG +/– to select the programme number with the channel. You cannot
select a programme number that is set to "Skip".
Programme/
Presets programme channels manually.
TV System/ 1
Frequency
2
3
4
5
6
Label
Assigns a name of your choice, up to five letters or numbers,
to the selected channel. This name appears briefly on the
screen when you select the channel.
AFT Allows you to fine-tune the selected channel manually if you
feel that a slight tuning adjustment may improve picture
quality.
You can adjust the fine tuning over a range of –15 to +15.
When "On" is selected, fine tuning adjustments are made
automatically.
LNA
Improves the picture quality of the channel (noisy picture)
when the broadcast signal is very weak.
If you cannot see any improvement in the picture quality even
if you set to "On", set this option to "Off" (factory setting).
Audio Filter
Improves the sound of individual channels when distortion
occurs in mono broadcasts. Sometimes a non-standard
broadcast signal can cause sound distortion or intermittent
sound muting in mono programmes.
If you do not experience any sound distortion, we recommend
that you leave this option to "Off" (factory setting).
~
• You cannot receive stereo or dual sound when "Low" or
"High" is selected.
Skip Skips unused analogue channels when you press PROG +/–
to select channels. To select channels you have programmed
to skip, use the corresponding number buttons.
.
Press F/f to select "Programme", then press
Press F/f to select the programme number you want to
manually tune (if tuning a VCR, select programme 0),
then press .
Press F/f to select "TV System", then press
Press F/f to select the best received TV broadcast
systems, then press .
Press F/f to select "Frequency", then press
G g
Press / to search for the next available channel. The
frequency band ("VHF Low", "VHF High" or "UHF")
is changed accordingly.
.
.
.
.
.