Interface Related Features
RS-232 Interface Features — cont. — cont.
ACK Character
START / END
Sets the ACK character from the set of ASCII characters or any decimal value from 000 to 255. Pad entries of less than three digits
with zeros, as in "005". To configure this feature, scan the "START/END" bar code above to place the unit in Programming Mode,
then the "Set ACK Character," followed by the digits from the Alphanumeric table in
your desired character. Exit programming mode by again scanning the "START/END" barcode above.
NAK Character
START / END
Sets the NAK character from the set of ASCII characters or any decimal value from 000 to 255. Pad entries of less than three digits
with zeros, as in "005". To configure this feature, scan the "START/END" bar code above to place the unit in Programming Mode,
then the "Set NAK Character," followed by the digits from the Alphanumeric table in
your desired character. Exit programming mode by again scanning the "START/END" barcode above.
3-20
PROGRAMMING BARCODES
DEFAULT SETTING FOR THIS FEATURE: 006
PROGRAMMING BARCODES
DEFAULT SETTING FOR THIS FEATURE: 021
Appendix C, Alpha-Numeric Pad
Set ACK Character
Appendix C, Alpha-Numeric Pad
Set NAK Character
Magellan
representing
representing
®
1000i