Steering; Power Steering - Hummer H2 2009 Owner's Manual

Hide thumbs Also See for H2 2009:
Table of Contents

Advertisement

The light in the button must stop flashing and remain
illuminated before the rear axle is locked.
Notice: If you try to lock the axle while the vehicle
is stuck and the tires are spinning, the vehicle's
drivetrain could be damaged. The repairs would not
be covered by the vehicle warranty. Always lock
the axle before attempting situations and/or
navigating terrain which could possibly cause the
vehicle to become stuck.
The locking rear axle will be disengaged when the
vehicle's speed is greater than 40 mph (64 km/h), if the
vehicle's battery is low and/or the transfer case is
shifted out of Four-Wheel-Low-Lock mode.
Notice: If the vehicle's axle is locked while driving
on pavement, the drivetrain could be damaged.
Repairs would not be covered by the vehicle
warranty. Do not use the locking axle on pavement.
If four-wheel drive is needed when traveling on
pavement, use only 4HI.

Steering

Power Steering

If power steering assist is lost because the engine stops
or the system is not functioning, the vehicle can be
steered but it will take more effort.
Steering Tips
It is important to take curves at a reasonable speed.
Traction in a curve depends on the condition of the tires
and the road surface, the angle at which the curve is
banked, and vehicle speed. While in a curve, speed is
the one factor that can be controlled.
If there is a need to reduce speed, do it before entering
the curve, while the front wheels are straight.
Try to adjust the speed so you can drive through the
curve. Maintain a reasonable, steady speed. Wait
to accelerate until out of the curve, and then accelerate
gently into the straightaway.
4-11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents