Using The Re-Dial Command; Using The Call Command - Hummer H2 2009 Owner's Manual

Using the Digit Dial Command
b g
1. Press and hold
responds with "Ready" followed by a tone.
2. Say "Digit Dial". The system responds with "Digit
dial using <phone name>, please say the first digit
to dial" followed by a tone.
3. Say the digit to be dialed one at a time. Following
each digit, the system will repeat back the digit it
heard followed by a tone.
4. Continue entering digits until the number to be
dialed is complete. After the whole number has
been entered, say "Dial". The system responds
with "OK, Dialing" and dials the number.
•
If an unwanted number is recognized by the
system, say "Clear" at any time to clear the
last number.
•
To hear all of the numbers recognized by the
system, say "Verify" at any time and the
system will repeat them.

Using the Call Command

b g
1. Press and hold
responds with "Ready" followed by a tone.
2. Say "Call". The system responds with "Call using
<phone name>. Please say the name tag" followed
by a tone.
for two seconds. The system
for two seconds. The system
3. Say the name tag of the person to call.
•
If the system clearly recognizes the name tag it
responds with "OK, calling, <name tag>" and
dials the number.
•
If the system is unsure it recognizes the right
name tag, it confirms the name tag followed by a
tone. If the name tag is correct, say "Yes". The
system responds with "OK, calling, <name tag>"
and dials the number. If the name tag is not
correct, say "No". The system will ask for the
name tag to be re-entered.
Once connected, the person called will be heard
through the audio speakers.

Using the Re-dial Command

b g
1. Press and hold
responds with "Ready" followed by a tone.
2. After the tone, say "Re-dial". The system responds
with "Re-dial using <phone name>" and dials the
last number called from the connected Bluetooth
phone.
Once connected, the person called will be heard
through the audio speakers.
for two seconds. The system
3-113