Table of Contents
Advertisement
Page 64
R E T U R N
P r e s s
< S E L E C T >
If NOT CURRENTLY TRACKING CARRIER:
M O D E : X X X X X X X X X X X X
D U R A T
I O N : h h h
MODE
xxÉxx is current acquisition mode
DURATION hhh:mm:ss Elapsed time since this mode was entered, in hours, minutes,
seconds.
R F
I N : 1
0 0
. 0 0 0
RF IN: n is only shown if optional RF switch is installed, otherwise omitted and fffff.ff fills to
left. The variable fields n, fffff.ff, dd.ddd, and r/r are defined in Settings Status above.
P R O G : p p p p p
T A G
S I T E :
The variable fields ppppp and tt are defined in Settings Status above.
[If tracking mode is entered while viewing any of the following three screens, the display will jump
to MODE & DURATION screen under TRACKING.]
S U B M O D E : x x x x x x x x x x x
SUBMODE xxÉxx is carrier acquisition sub-mode.
The following two screens are shown only if applicable (values non-zero):
N O
M P E G : n n n
N O
T A G :
Where nnn is number times unit timed out in GET MPEG sub-mode and receiver card was still
tracking. mmm is the number of times unit timed out in GET TAG sub-mode and Receiver card
was still tracking.
B A D
T A G : n n n /
B A D
H D R : m m m
Where nnn is number of times IRD has seen wrong (or corrupted) tag in GET TAG sub-mode,
and fffff.ff is the last oneÕs value. {if non-zero}; where mmm is number of times IRD has seen
an invalid network header while in GET COMPEL sub-mode.
UTY4000-011
: m m : s s
0 0 0 0 0
. 0 0
1 / 2
t
t
A T T E M P T S
m m m
A T T E M P T S
f
f
A T T E M P T S
f
f
f
.
f
f
Page 64 of 75
Advertisement
Table of Contents
