Table of Contents
Advertisement
Page 62
Otherwise:
f f
f
f
f
.
f
d d
. d d d
Where n is the number of the RF Switch output currently being selected. fffff.ff is the Carrier
Downlink frequency in MHz. aaaa is the Mode, as TEMP, PERM, or SEARCH. dd.ddd is the
Data Rate in Mbps. r/r is the FEC rate (1/2, 2/3, _, 5/6, or 7/8).
T A G :
t
t
P R O G : x x x x x
Where tt is the Tag number 0-15. aaaa is the Mode, as TEMP, PERM, or SEARCH. xxxxx is
the program number from the MPEG Program Association Table. This may be from 1 to 65525.
If omitted or entered as a Ô*Õ the unit will select the first available (Lowest Numbered) program
stream.
R E T U R N
P r e s s
< S E L E C T >
Settings Status report displays the current conditions and provides the following information:
Mode: aaaa is either PERM, TEMP, or SRCH settings. If TEMP, then hh:mm:ss is shown
and it is time remaining in insert.
RF IN: n is the (optional) RF feed, 1-4.
FREQ (Mhz) { Ô-Õ if searching }: fffff.ff is the carrier downlink frequency in MHz.
DATA RATE (Mbps) { Ô-Õ if searching }: dd.ddd is the Transport data-rate in Mbps.
FEC Rate: { Ô-Õ if searching }: r/r may be R= _, 2/3, _, 5/6, or 7/8.
TAG SITE: tt is the tag site 0-15 (Ô15Õ is special value, see section 3.8.4)
Program: ppppp is up to 5 digit program number (see section 3.4)
B.5.2
Carrier Status
C A R R I E R
P r e s s
< S E L E C T >
rd
Moves user to 3
level screens.
If TRACKING
M O D E : T R A C K I N G
D U R A T
I O N : h h h
MODE
Always shows TRACKING
UTY4000-011
f
r
/ r
h h : m m : s s
S T A T U S
: m m : s s
a a a a
a a a a
Page 62 of 75
Advertisement
Table of Contents
