Setting Method Of The Cooling/Heating Selection Eligibility - Daikin BRC1E52A7 Operation Manual

Basic Operation Method

Setting Method of the Cooling/Heating Selection Eligibility

Setting Changes
1
Cool
Set to
Cool
Return Setting
Cool
Set to
Cool
Selection Settings
2
Cool
Set to
Cool
Cool
Set to
Cool
Operation manual
21
See "Cool/Heat Selection Eligibility" on page 22 for an explanation of the
cooling/heating selection eglibility.
• Continue pressing Operation Mode Selector button
of the remote controller for at least 4 seconds.
(During backlight lit)
28
°C
A remote controller will not display
" " (Changeover under control) if a cooling/
heating selection eligibility is granted to the remote
controller.
• The display "
controller connected to the same outdoor unit or BS unit will start
blinking.
28
°C
* Vent mode setting changes are possible regardless of the
cooling/heating selection eligibility.
* If a cooling/heating selection eligibility is set in the "cooling/
heating selection remote controller" ( ), all the remote
controllers will display "
case, no cooling/heating selection eligibility can be set in the
remote controllers.
Refer to the operation manual provided to the outdoor unit for the
details of the "cooling/heating selection remote controller".
• Set a cooling/heating selection eligibility as explained below.
The display "
turned ON for the first time.
• Press Operation Mode Selector button of the
remote controller for which the selection eligibility
to be set.
28
°C
Then the cooling/heating selection eligibility will be
set and the display
" " (Changeover under control) will disappear.
The display "
will appear on the other remote controllers.
28
°C
(Use of Direct Buttons)
" (Changeover under control) on each remote
" (Changeover under control). In this
" (changeover under control) will blink when the power is
" (Changeover under control)
(VRV only)
BRC1E52A7
4PW71265-1 – 10.2011