Strong SM-RAZOR-ART1-M Instruction Manual page 7

Step 4. Attach the Arm Assembly to the Wall Plate
A. Loosen the two upper clamping screws on the arm assembly.
B. Align the arm assembly with the top and bottom rail of the wall plate.
C. S lide the arm assembly into position while lowering and pushing it toward the wall. Loosen the upper clamping
bolts more if the assembly will not clip onto the rail.
D. Tighten the upper and lower clamping bolts using the small 4mm Allen wrench (T1).
E. If the SM-RAZOR-ART1-BKT-20 is being used, the wall bracket end covers can now be installed.
Figure 8.
Step 5. Attaching the Display to the Arm Assembly
1. L ift the display and place it on the end of the arm assembly as
shown in Figure 10.
2. S ecure the display using the two Nylon washers (X), two metal
washers (V), and lock nuts (W). Be sure to place the Nylon
washer between the mount and the metal washer. This will allow
for easier tilt adjustments later.
3. Tighten the nuts with the 8mm socket wrench (T3).
www.snapav.com Support: 866.838.5052
SM-RAZOR-ART1-M Installation Manual
Figure 9.
Tighten
Screws
Figure 10.
Raise Block
Assembly
Tighten
Screws
(X) (V) (W)
Pg. 7