Strong SM-RAZOR-ART1-M Instruction Manual page 9

6.3. Adjusting Home Position (Fully Retracted)
The mount includes a home position latch that
secures the arm to the wall mount. This prevents
the display from being pushed away from the wall
due to cabling.
Note: Only the TV Plate side of the latch is pre-
installed. The home position latch clip requires
installation and adjustment.
1. Extend the arm out away from the wall.
2. A ttach the home position latch (Y) to the
wall arm assembly using the three screws
(Z) as shown in Figure 15. Use a #2 Phillips
screwdriver to adjust the screws.
3. L eave the screws loose enough to be able to
adjust the latch and set it at the top of its travel.
4. Push the display back to the wall.
5. I f no "click" is heard as the arm is pushed flat,
adjust the latch downward and test again.
6. R epeat these steps until a "click" is heard and the display latches completely to the wall mount.
7. A fter the latch is set correctly, tighten the screws completely.
6.4. Tilt Adjustments
Tilt adjustments usually do not require loosening
any bolts or screws. The tilt plate fasteners have
been pre-adjusted for easy adjustment with most
TVs. However, heavier TVs may sag due to the
extra weight.
If this occurs, evenly tighten the lock nuts on each
side of the end plate using the small 4mm Allen
Wrench (T1) until the display no longer sags.
(Figure 16)
www.snapav.com Support: 866.838.5052
Figure 15.
(Y) x1
(Z) x3
Figure 16.
5°
11°
SM-RAZOR-ART1-M Installation Manual
Tilt Adjustment Nuts
(2 per side)
Pg. 9