Hour Meter - Gravely Pro-Ride 254 Owner's/Operator's Manual

Hour Meter

Press and release the toggle button to shift
between different functions.
Press and hold the toggle button to reset the
timer or clear a service message.
The hour meter has three functions:
Timer (TMR1): measures the time spent on
individual jobs.
Press and hold the toggle button to reset the
timer to zero. TMR1 will then start measuring
engine run time until it is reset to zero again.
Service Alert (Chg Oil, Chg H Oil & Filter,
SVC Airfilter): reminds operators of the
maintenance interval for changing the engine
oil, changing the hydraulic oil and filter and
servicing the air filter.
The alert starts counting down two hours
before the maintenance is due. The meter
flashes the word, "Now," when it reaches the
maintenance time.
Press and hold the toggle button to reset the
maintenance clock to zero after perfoming
the service.
NOTE: The hour meter is preprogrammed for
the initial oil change at 25 hours and for 100
hours thereafter. The hour meter is
programmed for the initial hydraulic oil and
filter change at 75hours and for 400 hours
thereafter.
Display
Toggle Button
IMPORTANT: Keep a record of Hour Meter
readings for recommended Lubrication and
Maintenance intervals.
Deck Lift Lever
Deck Lift Lever
Deck lift lever raises and lowers mower deck
for mowing or transport.
Transport:
Push deck lift lever all the way forward until
lift lock engages.
To release the lock, push the pedal forward,
pull back on the transport lock handle, and
slowly release the lift lever.
DANGER: Before raising the deck
to the transport position, ensure
the PTO is disengaged and the
steering control levers are in the
park position.
Cutting Height
To change the cutting height, raise the mower
deck into the transport position. Turn the
Deck Height Adjust Dial until the desired
cutting height is shown and then lower the
deck to the cutting position.
The mower can be adjusted to mow from 1 –
6 inches (25 – 152 mm) height of cut. Grass
mowing height should be determined by
encountered conditions and personal
preferences.
The following recommendations are provided
as a guide for cutting height selection.
Lawns = 1 – 3" (38 – 76 mm)
Field Cutting = 3 – 6" (76 – 152 mm)
GB - 18
Figure 11